Visit Kawasaki Motor Corps., USA owners center for up to date service manuals, parts diagrams, ROK™ info, owner support, warranty info, Kawasaki Protection. View and Download Kawasaki Ninja service manual online. Motorcycle Accessories Kawasaki Ninja R User’s Manual And Installation Instructions JKAEXEE1 CDA EXEC JKAEXEEDA □ JKAEXEF1. [BOOK] Kawasaki Ninja r Owners Manual PDF Book is the book you Kawasaki NINJA R Assembly & Preparation Manual.

Author: Kill Daigore
Country: Montserrat
Language: English (Spanish)
Genre: Literature
Published (Last): 3 March 2004
Pages: 327
PDF File Size: 16.73 Mb
ePub File Size: 5.50 Mb
ISBN: 399-8-42155-398-2
Downloads: 87020
Price: Free* [*Free Regsitration Required]
Uploader: Shakarisar

If the throttle grip does not return properly, check the throt- tle cable routing, grip free play, and cable damage.


ECU Main Relay 9. Main Fuse 30 A 9. Guide Run the front brake hose through the guide.

Frame Ground 1 3. Main Fuse 30 A 6. Reserve Tank Hose 605r. Pad Lining Thickness Standard: If the corrugated fins [A] are deformed, carefully straighten them.

Pump the brake lever until it becomes hard, and apply the brake and hold it [A]. Turn Signal Relay 2. Joint Connector C 4.

locate a dealer

The relays and diodes can not be removed. Run the frame ground lead on the left side of the air cleaner housing. Service Code 51 Stick Coil 2: So, the heater itself can not be removed. Clutch Lever Free Play Inspection The thermostat continuously changes its valve opening to keep the coolant temperature at the proper level.


Battery 12 V 10 Ah 8. Fit the reserve tank hose into the groove on the reserve tank.

ninja r owners manual

The thermostat is a wax pellet type which opens or closes with coolant temperature changes. Lubri- cation points are called out throughout this manual, apply the specific oil or grease as specified.

Be careful not to get water or mud on the ABS hy- draulic unit. Use this table for only the bolts and nuts which do not require a specific torque value. If re- moved, the oil seal replacement may be required. If there is any doubt as to the condition of the reeds, re- place the air suction valve as an assembly. Friction Plate Thickness 2. The headlight comes on after the starter button is released and stays on until the ignition switch is turned off.

Got it, continue to print. To facilitate actual operations, notes, illustra- tions, photographs, cautions, and detailed descriptions have been included in each chapter wherever necessary.

Air Cleaner Housing 2. Tighten the two clamp bolts alternately two times to ensure even tightening torque. If the oil leakage is found on it, replace the shock absorber with a new one.


Torque – Switch Housing Screws: Main Fuse 30 A 8. Page 71 Install nnija new element so that the screen side faces up- ward. Also, replace the steel plates if their teeth are damaged. Battery cable making poor contact Load excessive e. Starter Relay with Main Fuse 4.

Replace any damaged gears or gears with excessively worn dogs or dog iawasaki. Torque – Oil Filter: Drive Chain Slack — — — Fuse Box 1 9. Main Fuse 30 A 3.

Fork Oil Level Gauge: Hook Hold the rear brake light switch lead and the crankshaft sensor lead. Clamp with Damper Hold the rear brake hose. Place a strip on each journal parallel to the camshaft in- stalled in the correct position. Also, check to see that each cotter pin is in place and in good condition.