Table Saw mm (“) MODEL INSTRUCTION MANUAL SPEC I F ICATIONS 5/8″ Cutting capacities Blade diameter Arbor hole I ” (/4″) 1 N o . ENGLISH (Original instructions) INSTRUCTION MANUAL Table Saw MLT DOUBLE INSULATION IMPORTANT: Read Before Using. 1 ENGLISH. Power tool manuals and free pdf instructions. Find the user manual you need for your tools and more at ManualsOnline. Makita Saw User Manual.

Author: Gardarn Shataxe
Country: Senegal
Language: English (Spanish)
Genre: Photos
Published (Last): 13 June 2007
Pages: 225
PDF File Size: 16.18 Mb
ePub File Size: 16.44 Mb
ISBN: 258-8-97803-178-3
Downloads: 40662
Price: Free* [*Free Regsitration Required]
Uploader: Tygobei


Always stop the tool and wait for dado head to come to a complete stop. Always use the correct ring for the arbor hole of the blade you intend to use. Manufacturer reserves the right t o change specifications o f parts and accessories wlthout notice. Never use nails in push block. Secure slide rails with bolts provided with the tool. Attach this tool w i t h screws either t o the optional stand or t o a steady stand or bench w i t h good chip ejection. Hole diameter 8 mm mm 1 1 mm 1.

If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Disconnect the tool before making any adjustments.

Remove the center cover. Use clamps or a vise to makiga work when practical. Bolt or screw the Never carry the tool by the cord or yank it to disconnect it from the socket.


Push stick 1 2 3 11 4 1. When not in use, take off the key and the machine should be both “OFF” and unplugged. Feed the work forward with the hand on the rip fence side. Slide table 3 1 Remove the table insert on the table.

Makita 2708 Manuals & User Guides

Loosen the knob on the Do not expose power tools to rain. Always install the blade guard following the instructions out-lined in this manual. Guard against electric shock. If your grip should slip, the wrench may come off the hex nut, and your hand could strike the sharp blade edges.

Set workpiece on i t s edge. Use of Miter Gauge Slide the miter gauge manyal the thick grooves in the table. Sub-table R Part No. Don’t show me this message again. Most frequently used for general carpentry.

The green-colored rigid ear, lug, etc. Insert the riving knife into the blade guard mounting portion stay. Use saw-blade guard and riving knife for every operation for which it can be used, including all through sawing operations.

Inspect extension cords periodically and replace, if damaged. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. When using a dado head set, the depth of cut is not indicated by the pointer.


Install the dado head with the teeth pointing down a t the front of the table. Never use gasoline, benzine, thinner, alcohol or the like. Do not perform any operation freehand. Never attempt to move the table saw by gripping these holders. To know the depth of cut, you must measure it with a ruler. Never use nails in push block.

Before plugging in the tool, always be sure that the tool is switched off. Push sticks MUST be used for ripping narrow workpieces to keep your hands and fingers well away from the blade.

Use of Miter Gauge Slide the miter gauge into the thick grooves in the table. Most frequently used for general carpentry. Never wear gloves when operating the tool. Bolt M6x14 W i t h Washer1 Hex. Adjust the depth of cut a bit higher than the thickness of the workpiece.

Cluttered areas and benches invite accidents.

Saw Makita Instruction Manual 52 pages. After the desired angle setting i s reached, then lock the lock lever by pressing down firmly t o secure in place.