GSM/GPRS Communicator. The BGSM-G gives total confidence in all security and surveillance applications and is the ideal way of completing whatever system . (see instructions), and then close the B-GSM. + Screw the 3[G]. In the event of GSM network signal fail- ure a signal as per figure 3b will be present on terminal . The BGSM-G-EU is Bentel’s all new universal global system mobile (GSM) alarm communicator is a versatile device that accommodates end-users that are not.
|Published (Last):||24 November 2004|
|PDF File Size:||18.10 Mb|
|ePub File Size:||9.85 Mb|
|Price:||Free* [*Free Regsitration Required]|
The performance of this Device depends greatly on GSM Network coverage, therefore, it should not be mounted without first performing placement tests to determine the best location manuxl reception minimun one green LED is ON.
Remove the screw and the front cover .
Lay the cables, then pull them through the cable entry . Enhancing home automation with IoT OctoberElvey Security TechnologiesProducts, Integrated Mmanual By automating elements which are electronically driven, homeowners are given the power to improve their quality of life by implementing these enabling technologies and controlling them via a smart device.
Using anchor screws not includedmount the cabinet to the wall. The communicator is protected against tampering and provides tamper signals on two terminals, while the device can also be programmed and controlled via a PC software application which is available as an accessory.
Route wires as indicated in Figure 1. This Week’s Editor’s Pick. Before inserting or removing the SIM card, please ensure the unit is powered down.
Using the connector , connect the GSM Module . Reattach the front cover  securely to the cabinet.
The SMS dialler function manages telephone numbers and sends trouble alert, periodic manuaal and pay-as-you-go balance messages. The content of this article Your name Your email address Their name Their email address Your message The details submitted in this form will not be shared with any third parties. Description This Device manages SMS and Central Station transmissions and bgsmg- simulate the land line in the event of trouble land line down or even substitute the land line completely in areas where the GSM service is provided and where the land line is not available.
The details submitted in this form will not be shared with any third parties. Check for cable conduits and water pipes before drilling.
BGSM-G Universal Alarm
This Device has 4 Outputs which can be set up from remote locations or used for status signalling. There is also an account supervision feature that sends out information via IP in the event of a communication failure.
It has home remote automation capabilities and a full event report program. More information about Elvey Security Technologies. This Device must be installed indoors in a non-hazardous location. The communicator connects the alarm control panel to the GSM network to report alarm signals directly to the monitoring station receiver, and is compatible with any control panel that communicates using the Contact ID format.
BGSM-G Universal Alarm
Fit bgs-mg antenna  ensure that the bolt  is fastened tightly. If both are ON, it indicates perfect coverage.
It can effectively monitor optical lengths of up to km per controller for buried, and 80 km for fence installations. Using the cabinet, mark the 4 screw locations then drill the anchor screw holes.
This Device should be located in a safe dry place away from radio transmitters and similar devices. Complete the connections on the terminal board .