DS chip is commonly used as DS RTC module which comes with a 32 kHz crystal and on-board battery backup all in a small SIP. Part Number: DS, Maunfacturer: Maxim, Part Family: DS, File type: PDF, Document: Datasheet – semiconductor. DS The DS trickle-charge timekeeping chip contains a real-time clock/ calendar and 31 bytes of static RAM. It communicates with a microprocessor via.

Author: Meztishicage Kagrel
Country: Central African Republic
Language: English (Spanish)
Genre: Photos
Published (Last): 6 June 2011
Pages: 228
PDF File Size: 6.81 Mb
ePub File Size: 15.38 Mb
ISBN: 500-9-83785-749-4
Downloads: 26667
Price: Free* [*Free Regsitration Required]
Uploader: Fenrinos

You are datashewt advised to use a DSwhich is very reliable and accurate and needs only a battery to run the crystal is inside the DS See the datasheet for full specifications and a circuit.

To prevent that, the DS has a buffer to store the clock data. I was noted that the code could be improved. The Vcc1 is for a battery or a rechargable battery or a supercap.

If datashfet byte is read, the addres is written first. Related Hardware and Initiatives. The Year data of the DS is only two digits Use it with Arduino 1. Arduino on other Chips. The code below contains basic interface functions for the DS Sources for Electronic Parts.

  LEI 11419 PDF

Datasheet «DS1302»

That is also wrong. Datasheett Setup and Configuration. That way the check for the 7th bit is not needed, since the line is always released.

The DS can be easily connected to the Arduino. This is a cheap module with the DS That would result in bad clock data.

The last clock pulse of dqtasheet address using the rising edge is also the first clock pulse of the data to read using the falling edge.

DS RTC Chip/Module Pinout, Specifications & Datasheet

The Year ‘0’ isand not or Some schematics on the internet have pull-up resistors on the three interface lines. It has a Leap-Year compensation from up to for a value of The standard date and time functions like: Other schematics use two 22pF with the crystal.

A crystal of The three pins for the interface should avoid to use the internal pull-up resistors of the Arduino. So the code has to detect that condition to prevent an extra clock pulse.

The most used name is “3-wire interface”. For the name of a month, this page contains many languages: The chip datasbeet 31 bytes of ram.


During reading, the clock could rollover. For more info pleae look at this Forum Post. That buffer can be read in a single communication session, called a “burst” mode. They often don’t work very well. Cheap modules with the DS and DS have often problems with the crystal and the voltage.

At this moment there is no official library for date and time functions for the Arduino. The most used date and time functions for the Arduino: The page at maxim for the DS with all information and daasheet The data in this ram will get lost if the Arduino is off, and the battery or supercap gets empty. The playground is a publicly-editable wiki about Arduino. This circuit has pull-down resistors which are an extra, in many cases ds302 are not needed.