INIC Initio Corporation. 1. INIC USB to SATA Bridge. Specification. Version August 10, Initio Corporation. INIC initio datasheet pdf data sheet FREE Datasheets (data sheet) search for integrated circuits (ic), semiconductors and other electronic components such . inic, USB to SATA Bridge Overview The INIC provides an advanced solution to connect SATA devices to w,
| Author: | Mikar Gashicage |
| Country: | Thailand |
| Language: | English (Spanish) |
| Genre: | Finance |
| Published (Last): | 19 September 2007 |
| Pages: | 385 |
| PDF File Size: | 12.26 Mb |
| ePub File Size: | 6.73 Mb |
| ISBN: | 816-9-93576-153-4 |
| Downloads: | 86838 |
| Price: | Free* [*Free Regsitration Required] |
| Uploader: | Vutaur |
I found a post here — http: You need proper tools. The drive was not dropped or mishandled. Access LED blinks same interval as dayasheet 7. ROM U12 is unique to the drive, contains adaptives and ROM code that must match overlay – module 11 on platters so the drive will properly work. Meaning that the drive will take huge amount of time to clone and even to copy a single file out of it.
Hi folks, thought I’d post a current status update on this recovery project.
Is this procedure documented? You can buy PCBs out of ebay. Test it first by darasheet a few sectors at random places — start, middle, end. Access LED is steady for about half a second 2. Looking for advice on what to do.
It can be done with firmware tools and even with some free scripts and tools: So, let’s summarize your options in case of: Maybe a hardware based cloning tool might help as it will send soft-reset, hard-reset and power off-on the drive as needed.
INIC-1607E, INIC-1608L, INIC1610
The PCBs arrived this afternoon. In any case if you don’t have a “decent” access speed to the drive firmware will have to be patched.
Now i would advise you inic–1608 start by reading this: Your original board is So drive cloning or similar things dd, etc. So ddrescue is out of the question otherwise I wouldn’t be here in the first place!
U14 deals with USB bridge aspects as ibic-1608 ASME and buy your own drive. The SMART data I can understand fully trust me — been doing this part of it for about 15 years now, quite familiar with ATA protocol as well and see absolutely no anomalies, so I’m left thinking there is something more nefarious going on.
The access LED interval also datasheeg varies. Clone the drive and then run a file recovery program. This is because of some issues on some firmware datasheett WD drives not dealing with sectors that are pending relocation properly. So I’m his best bet, barring physical damage. Switch to full style. I’m referring to the process described here: Drive spins up 3. I really don’t feel like sitting around spending hundreds of dollars “hoping” I get a My Book device that uses said chip.
After about 45 full seconds or so, 4 happens, rinse lather repeat Are these flashable using some kind of serial or TTL interface to the drive itself?
INIC_PDF Datasheet Download IC-ON-LINE
You do not have the required permissions to view the files attached to this post. Where would I find a replacement firmware other than a donor PCB? You simply don’t have the knowledge, equipment, or experience to pull this off. Hard drives are not lawnmowers, washing machines, or coffee makers. Sounds like a directory problem, or bad sector 0, or possibly a firmware issue.
About firmware, SA, etc For advantages of hardware cloning read here: If the answer to 2 is “no, nothing’s available right now”, does anyone have onic-1608 further explaining the problem described here, section “Managing Catasheet Problems”?
Cheapest available option might be WDMarvell. A continuation of 2: