Find great deals for JBL Urei Electronics watt Power Amplifier THX. Shop with confidence on eBay!. Jbl Pdf User Manuals. View online or download Jbl User Manual, Instruction Manual. Have a chance to purchase a amp decent?? Did JBL produce their amps or did they farm them out?? In the past, I found several for.
|Published (Last):||24 September 2006|
|PDF File Size:||4.74 Mb|
|ePub File Size:||10.74 Mb|
|Price:||Free* [*Free Regsitration Required]|
Log in or Sign up.
They have all the right stuff for great jgl. Do you already have an account? Just thought I’d share my experience bringing an ebay bought JBL into service. The power supply caps and troublesome electrolytics in the speaker relay circuit all looked to have been replaced already. No, create an account now. Here’s the system I’m slowly putting together: Share This Page Tweet. I couldn’t find an official spec in the manual linked, but one of the threads above claim its 0.
Yes, my password is: Thankfully there are some great threads out there that helped 62260 a lot.
amp, is it good
I also checked the bias on the output devices which seemed to be a bit hot at about 0. I’m just using a pair of JBL surrounds to test right now, but was happy to find there was no hum or hiss at all with both channels set for max output.
Luckily the cleaning seemed to have done it, and both channels were now strong and reliable with no change from pressing on the it and flexing the board. Discussion in ‘ Solid State ‘ started by miscrms00Oct 21, Your name or email address: My bjl seemed to loaf all the time, you couldn’t tell if they were on by touching the top.
After it dried out I replaced the cover, glued back on the magnet that had fallen off and soldered the relay back onto the board to test.
JBL Urei Electronics 6260 600-watt Power Amplifier THX
At that point I was thinking I might have to replace the relay, so I removed it from the board completely. I reflowed the solder on the relay pins on the back side of the board, as well as a number of the other components in that area but still no change.
You must log in or sign up to reply here. Connecting speakers and pre-amp I found that I only had output on one channel and that seemed a bit soft. Anyways, can’t keep them all, the ‘s did not survive a sell off.
Coil voltage now read I also checked the voltage on the coil pads on the board and it measured 25V without the relay present. Plenty of metal die T outputs for more than adequate power handling.
Boat anchor transformer that makes the amp tricky to move around. SoCal SamOct 21, A few useful links: Couldn’t tell any difference in volume or clarity, so left it there. I had a pair of ‘s.
Output DC on the speaker terminals was measured at mV.